Last night saw more progress on the body with one of the wings being fitted. We started by setting the galvanised inner wing in place.
The front wiring loom runs up inside the wing. The plugs for the lights had been cut off on this side.Luckily we had them on the loom from the 90 we used as an engine donor, so they were cut off, the exposed wires were cleaned, and they were soldered on before we went any further.
A live and switch wire for the winch were also run down the chassis leg and covered in plastic armour for protection.
The outer wing top and side were then fitted over the inner wing, and after a lot of adjustments everything was tightened.
Phil's Toys 